Used for home appliances internal connecting and other equipments
Component brands can be AMP, JST and MOLEX according to customer's specific requirements
UL-, CSA-, CCC- or VDE-approved
OEM and ODM orders are welcome
Customized assembly drawings or designs for electronic appliances are accepted
Packing: according to customer's requirements
1.This product exported Mexico, the United States, Poland,Canada,England,and other countries.
2.We guarantee each product will be checked.
3.If there are bad products, we will promptly pay compensation to customers without any charge.
4. We also sell a lot of similar electronic products, varieties, good quality.
- Q:Why this cable has not yet been certified
- The manufacture of wire and cable is completely different from that of most electromechanical products
- Q:Wire pipe inlet air switch trip how to do?
- Put the water clean, with a table to measure the insulation resistance between the lines, as long as no less than 1.5-2 can.
- Q:Seeking the basement of the outer wall piercing the cable after the casing, how to solve the water (200 points online)
- If you use the color component output, you have to have the color difference component interface. With the color line facing the same color on the line. AV line of the yellow plug is the video, red and white is the audio delay Han silhouette cellar jealous of the tea, according to the same color received TV
- Q:How to distinguish between power cables and electrical wiring on drawings
- According to the control cable and the power of the different layers of laying, if the power cable to be multi-layer need to have 300mm spacing (or load capacity is large enough), if it is control cable, casually laying, if the laying of power cable laying below Layer, above the laying of control cable, but not too much affect the power cable cooling. If the high-voltage cable and low-voltage cable in principle do not allow common laying.
- Q:When pouring concrete is how to put the tube
- Oh, the pipeline is poured before the layout according to the design drawings.
- Q:Building decoration wiring pipe elbow with yellow wax tube can you?
- Indicating that your Apple data cable is not original, no effect, re-plug the general and you can use the.
- Q:What is the difference between wires and cables?
- The introduction of the device in the form of: sealing ring (sealing ring is to achieve the required protection level of the shell and the use of cash-saving brush to help find the silent material or elastic material parts) type of introduction device; casting solidified packing seal Type introduction device; metal seal ring introduction device
- Q:What is the difference between a kbg threading pipe and a PVC threading pipe?
- May be charging head of the problem, the line may also be a problem. If the warranty can be free for the change.
- Q:Connect the computer to the TV. The The Using the HDMI cable. The The Line no problem. The Why not even after the audio video. The The Amplifier is Denon 1311
- BV1 * 2.5 is a 2.5 square line. 2 * 2.5 is two 2.5 square lines. 3 * 2.5 is three 2.5 square lines. 4 * 2.5 is the 4 2.5 square line lighting wire power cord with 2 * 2.5. Light wire with 1.5 is enough. Socket (pipe) with three 2.5 square lines, you can also use 3 * 2.5 a. 4 * 2.5 for three-phase motors.
- Q:What is the cable for rvv? Is it a power cable or a control cable? What is the cable?
- The installation process is a certain requirement, high and low voltage cable bridge should be installed separately as usual, a wall laying vertical pipeline (slot) or installation equipment, the power distribution between the depth of D1 = 1200 ~ 1500mm; weak Between the deep distance from the D2 = 1100 ~ 1400mm more reasonable. The length L1 and L2 between the power distribution and the weak can be determined according to how much electrical equipment and pipelines (slots) are installed in the room. "Civil building electrical design specifications" proposed "shaft size in addition to meet the wiring spacing and terminal box, distribution box layout must be the size, but also in the box before the left not less than 0.8m operation, maintenance distance" requirements. In the weak equipment, the operation and maintenance distance is not specified in the provisions of the Code for Electrical Design of Civil Buildings, but it should not be less than 0.8m. Cable to wear steel pipe wiring, should be reserved in the floor steel pipe, wiring should be completed after the plug fire fire blocking material. Cable bridge installation should be horizontal, the maximum sag should not be greater than 10 mm; proposed separate installation
We are implementing mature quality control systems and make sure our products are perfectly qualified. Our company always maintains "Improving quality, Reducing cost, Continuing improvement and Satisfying customers' needs" as our quality policy. We aim at saving your time and money by providing a single source for the entire cable areas.
1. Manufacturer Overview
|Annual Output Value
||US$10 Million - US$50 Million
||ISO 9001:2000;ISO 14001:2004;ISO/TS 16949
2. Manufacturer Certificates
|a) Certification Name
3. Manufacturer Capability
||31% - 40%
|No.of Employees in Trade Department
||3,000-5,000 square meters
|No. of Production Lines
||OEM Service Offered Design Service Offered Buyer Label Offered
|Product Price Range
||Low and/or Average