Q:What is the B axis of the NC table of the horizontal machining center and what is the mode of movement?

Radial rotation of main shaft. A is axial offset, and the C rotates for the table

Q:Bed electrical control technology, as shown in the diagram, ask: if the work station to run at both ends, want to stay for 10 seconds, how to control the design of the circuit?

A time relay in his one normally open contact to coil KM1, KM2 series electric locking loop, that is to say the motion of the platform to end, after the pressure switch, give him a ten seconds delay to contactor inversion of control power, so that we can realize that work Taiwan stop 10 seconds, ten seconds to remember to pay attention to the time relay is reset, the coil circuit loss of electricity, or directly to the other end of the reverse.

Q:I used the Z axis is on the workpiece surface, and to the factory processing center, why always on the workbench, I do not understand, please master detailed instructions on its tool steps and intentions, high marks ~ ~ ~!

When programming, the base plane is the workbenchThe aim of the tool setting is to determine the position of the origin of the program in the coordinate system of the machine tool. The tool point can be located on the part, on the jig or on the machine tool. When the tool is set, the tool point should be coincident with the cutter location. The trial cutting method is the most widely used tool setting method in practice.

Q:How do I build a workbench in my world?

To make a workbench, just press the E key, and use 4 boards of any kind in the backpack to be square, which can be integrated into a workbench for advanced synthesis.

Q:I want to install the cylinder on the rotary table. I want to use pneumatic rotary joint to solve the problem of trachea winding. Can you tell me if the rotary joint is connected to the cylinder or what?

It's so complicated. Generally, the joints can be rotated at a certain angle, but if you turn the circle, the pipe may be twistedYou don't seem to be able to solve the problem of trachea entanglement with this method.. If you have any doubts, you can consult E.MC's Pneumatic technologist directly

Q:What is the height of the press table from the ground?

About 80 centimeters, of course, because the mold closed height reasons, you may need to remove the workbench table, so it is less than 80 centimeters.

Q:How do you install the fixtures on the milling machine table?

Just press the T bolt and the platen. The general milling machine uses M14 bolts

Q:What is the difference in function between the indexing table and the turret of NC machine tools?

Are you light industrial?

Q:The working principle of the machine table of the left and right!!! Please, urgently.

Your question is not very clear. What do you mean by the worktable of the machine tool? Plain Miller or flat mill? Or the machining center?The general principle is the same. The movement direction of the worktable is controlled by the limit or reversing device of the worktable and the reversing switch. Is to use the weak current to control the strong electricity. Only numerical control is done by means of feedback. All motors (service motors or AC and DC motors) are passed to the lead screw (ordinary lead screw or ball screw) to complete the movement of the table.

Q:In the hotel, a table called the cooker, the cooker is what to do with it?

Cooker. Just take the plate. To serve the fried dishes. To help master handyman. In fact, they are right