Q:How high should the water inlet angle of the bathroom cabinet be?

It is generally 30-55 cm, angle valve to meet the size will be Water Leakage phenomenon, water must be matched through quality, recommended the use of star angle valve with ten pipes, stainless steel wire braid, really good!

Q:My house is a new house decorated, hot and cold water pipes are gone, showers are installed.

Hot and cold water also need angle valve of water heater each need a large flow angle valve angle valve ~ this thing is the quality of durable products bought that if you bought a little good can be used for many years with poor quality with less than a year on the bad Jomoo ciasia angle valves are good you can go online see

Q:Where do I need angle valves?

Water pressure is too big, can be adjusted on the triangular valve, turn it down a little;The function of the switch, if the faucet leaks and so on, you can turn the triangle valve off, you do not have to shut the main valve;Handsome and generous. General new house decoration is indispensable plumbing fittings, so when decorating a new house, designers will also mention.

Q:Can the toilet water inlet angle valve be replaced by water tap?

Are you sure you can tap both ends? No, it certainly can not be used insteadThere are several other issues:1, faucet interface is higher than the toilet tank, the current general water line is at the bottom of the toilet, so it is difficult to replace

Q:What is the eight patriarch, seems to be a kind of angle valve

There will be no danger. There are two kinds of red label, which is used to distinguish hot and cold water. It is convenient to use.

Q:So the electric water heater doesn't keep under pressure. Is it possible to install the valve? 40

Generally speaking, the pressure refers to the pressure of the tank, rather than the pressure of the water supply (the highest is also more than a dozen kilograms). If the angle valve is closed at the inlet, the user will not turn on the hot water valve when it is normally heated. At this time, the liner inlet and outlet are closed, still heating, equivalent to a boiler! Very dangerous!

Q:The cold water outlet and the hot water outlet of the triangle valve marked a blue one red, in fact the same? My home to install a hot water heater valve installed, but also used to transfer it?

The color is just for you to distinguish between hot water and cold water.

Q:Angle valve in screw inside out how to do

Inside and outside the wire connector, usually used for faucet elbow into the wall too much, and the triangular valve can not be properly connected with the pipeline faucet elbow case to lengthen effect.

Q:I bought two pairs of Moen angle valve on the Internet, but the opening of the core hole is not the same, the top two are hot water, just the opposite, the following two are cold water is not the same, I ask, this normal? Can I use it properly? Will it leak?

Inside the ceramic core is screwed into the thread, so after the installation inside the opening direction is not consistent, but will not affect the flow of water, because the result is through the air, even invisible openings, like water through the empty place directly to the water outlet flow out, does not affect the flow, can not normal use.

Q:Should the radiator be fitted with angle valves?

You are central heating, plus no need, the pipes are connected in series. Maintenance time to shut down the main valve on the line, and if there is water separator, it is not necessary.