Q:Which mobile shear fork lift is better

Mobile shear fork lift There are four major systems, The mechanical structure system,

Q:How does the table in the middle of the tatami mat go up and down

Need to buy the metal platform of suitable height, use screw to install small table board. Steps are as follows: Installation: desktop lock desktop board with screws on the top of the lifting platform (such as manual lifting platform should be first in the middle of the desktop is boring, the size of the hole to match the rocker tank size).

Q:Can the stepping motor drive the hydraulic platform?

The hydraulic platform is driven by an oil cylinder, and the motor drive is a completely different way through mechanical means (screw, chain, gear, rack, etc.). In addition to mechanical means, depending on the power size, the step motor usually means that the equivalent power is not much, the maximum is a few hundred watts. The hydraulic platform is generally heavy, so it's unlikely. Or do you use a step motor to drive the hydraulic pump? It can, but also to consider the power problem, said earlier, smaller power stepping motor, if the original motor is a few kilowatts, certainly not.

Q:What are the elevating institutions

The method of moving is different: fixed, drag-type, self-propelled, vehicle-mounted and drivable. A lot of hydraulic platform manufacturers also produce tyre boarding bridge, ground boarding bridge, and this kind of introduction.

Q:Introduction of vertical elevator milling machine

Vertical knee-type milling machine is a general-purpose milling machine. Vertical milling machine by end milling cutter, end mill, cylindrical milling cutter, saw blade milling cutter, wafer cutter, end milling cutter, and various forming milling cutter for machining various parts.

Q:How do you remove the horizontal universal elevator milling cutter

When the milling cutter is removed from the vertical milling machine, the lever nut must be released and then the end of the rod is gently tapped. ; You should not release too much, as long as you have some loose space. When you release too much, the thread connecting the rod and the milling cutter is too short, and when you tap, you slip and even drop the knife.

Q:Hydraulic platform repair work instruction book, trouble which big man helps to provide

Jinan zhihua elevator machinery co., LTD. Is specialized in the production and development of a unit hydraulic elevator for the oil and oil. The lift is raised all the way up. In this position, the hydraulic pressure should be 40 to 50 mm above the bottom of the box. Hydraulic oil is a variation of dark, sticky or grit, such as a discovery should be replaced in time (32 # hydraulic oil) The lift is maintained every year Check all hydraulic pipes and connectors. The pipe shall not be broken, the joints shall not be loose, and all the joints must be tightened.

Q:How does the platform maintain

Remove and disassemble the valve, and remove the valve core and remove it from the new installation. Put all the hydraulic oil in the tank into the tank, remove the oil absorbent filter, and put it back in the tank. The oil tank refilled with new oil.

Q:Put a large beaker of water on a horizontal platform and put a light glass upside down in the water

Although the inside of the glass is going up, the increase in the pressure of the gas is less than the glass, so B is right.

Q:How much is the 8 square meter tatami mat

Wants to see you with what kind of wood, to make what kind of structure, whether or not to do lifting platform, finally, custom matching straw mat, ranging from several thousand to tens of thousands of, I will ask carpenter in my attic made a simple platform of more than 20 cm from the ground to add a row of little cupboard (pictured)