Q:The electric kettle is dry. Can it be repaired? What about the warranty?

Fuzhou where I can repair, I do not know, but need to remind you of the point is that we must find higher qualified places to repair, otherwise, such as electric kettle heating products, once the repair is not good, easily lead to fire.

Q:Midea electric kettle shows E2 what's the trouble?

The principle of computer hardware troubleshootingThe computer is out of order and usually has some clues. Generally, the following principles should be followed in carrying out the inspection and diagnosis of faults:1. first check the machine parts, and then check the machine partsIf the host or monitor does not turn on the light, check the switch, the safety, the socket, the circuit breaker, the short circuit and so on. Then confirm the parts outside the machine and then open the case or monitor to check. Open the box, plug and socket system board to observe whether the skew, resistor, capacitor pin is touching, the surface is burnt, the cracking surface of the chip on the motherboard, the copper foil is blown; to check whether the foreign body fell between the motherboard components caused by short circuit, can also go to see if there is a local line, printed circuit board on board burnt discoloration (copper) whether fracture etc..

Q:The principle of automatic power-off electric kettle?

Automatic temperature control circuitThe pot boil dry pot is a power automatic temperature control circuit in series. The temperature sensor circuit. The boiling point of water is one hundred degrees, when the water is dried after the temperature will exceed one hundred degrees, when the temperature sensor will disconnect the circuit. The temperature sensor is simple bimetal, commonly used in electric iron electric water heater appliances. Many kinds of temperature sensors. And the semiconductor temperature sensor. It has the advantages of simple structure, safe use, good reliability.

Q:How to distinguish the true and false of an electric kettle?

The most important thing is to look at the product logo on the product, and you and online or beauty shop to see the beauty of the logo is exactly the same as genuine. There is to see whether there is no product production date, certificate, warranty logo, etc.. These are available, no problem, it must be true

Q:How to remove the water pollution of electric kettle?

Boil the kettle and remove the potatoes. Just buy a new kettle, put half a kettle over the potato, and then fill up the water, the cooked potatoes, so that later will not be dirty water. Note the kettle boiled potato, the wall do not scrub, otherwise you will lose the cleaning effect; as has been flooded with the old kettle scale, boiled one or two times using the above method, not only the original scale will gradually fall off, and can play the role of scale to prevent further accumulation.

Q:The electric kettle is burnt out. Will it be repaired?

This depends on your kettle, if the heating tube is to remove and change, will go down with the same power, like, get on the mounting hole heating tube installed just fine, some are not removed, you have also bought one.

Q:Plastic electric kettle for a long time, it will be poisonous?

Used for a long time, plastic aging, there will be poisonous substances decomposition

Q:SUPOR electric kettle water opened, not trip what is the matter?

Thermal switch damage or poor contact.220V series switch and a thermal switch power after receiving the electric heating tube, plug in the power, press the switch, electric heating tube power through a thermal switch after arrival; when the pot temperature rise to a thermal switch action value, switch in the spring because of rebound deformation, the electric power source contact detachment.

Q:Why does the electric kettle trip when the electricity is on?

If there is a multimeter, the multimeter can be used to measure whether there is a short circuit fault in the shell of the fire line or zero line and kettle. If not, it can be used safely.

Q:Stainless steel electric kettle surface, why not add a layer of heat insulation plastic? Avoid water when touching the electric kettle. May I ask why?

Because the appearance of more high-grade stainless steel belongs to material (stainless steel easy to leave fingerprints, dirty problem is not apparent in the store inside), outside with plastic, the appearance is similar to white goods, reducing the.