Q:The electric kettle is broken. After opening it, I don't know where it is broken. Somebody show it?

You open the base, there should be no problem, the kettle is the most vulnerable parts of the heating water heating parts, repair costs as well as directly from the new one, probably about 50 yuan will be able to buy one

Q:What is the structure of an electric kettle?

The structure and working principle of electric kettle power heating electric kettle, the water temperature gradually increased to 100 degrees, the water begins to boil, the bimetal steam steam impingement on the switch, due to thermal expansion and contraction function, double sheet metal expansion deformation, open top switch contacts disconnect the power supply. If the steam switch failure, the water in the pot will always burn down, until the water is boiled, the sharp rise in the temperature of the heating element, heating plate at the bottom of the two double metal sheet, because of the effect of heat conduction temperature rise sharply, swelling deformation, disconnect the power supply. So the safety protection device of electric heating kettle is designed very scientific and reliable. This is electric kettle three heavy security principle.

Q:Where is the temperature sensor in the electric kettle?

The other is water induction, some are on the handle switch, others are in the pot with a metal tube, the steam is brought to the pot low, triggering the temperature control switch.

Q:After the electric kettle has been boiled, the switch has not yet jumped. Listen to the "bang" at the socket. Then the air switch and the socket switch are tripped

You can check the repair, usually the thermostat or heating core damage.

Q:Must the electric kettle be filled with water?

Proper use and maintenance of electric kettles(1) the liquid injected into the pot shall be at least several millimeters higher than the top surface of the heater, but shall not exceed the required maximum water level.(2) when using, must install water first, after electrify, must not electrify first, after installing water.(3) do not use electric kettle to boil things with acid, alkali and salt so as not to corrode kettle body and heater.(4) when using, often remove the scale or other stains on the electric heater, otherwise it will affect the thermal efficiency and life of the electric heater.

Q:The electric kettle can't be heated

This is usually the temperature control switch is mounted on the side of the kettle bottom or near the bottom of the damage, you can see the open kettle, is cylindrical in shape, both sides have a lead screw mounting hole, there are two connecting wires, remove the rear can see 110 degrees or 105 degrees Celsius on the table the surface, some electric kettle has two such switch, only the installation position is different, the function is the same.

Q:Why can't the electric kettle be used?

Bad, and find someone to see if the heating tube broken wire, did not burn, that is, other failures, cost little, good repair. When the wire is broken, there is no need to repair it, because the heating tube is mostly connected with the kettle body. The heating pipe leakage, also not good repair. Temperature protection switch is generally not bad, plug interface sometimes bad contact, find contact bad reason.

Q:On reducing the power problem of electric kettle

Open 2 electric hair dryers at the same time. If you do not jump, go and buy a kettle

Q:Working principle and maintenance of electric kettleWhat is the principle often bad place where ah

The structure and working principle of electric kettle power heating electric kettle, the water temperature gradually increased to 100 degrees, the water begins to boil, the bimetal steam steam impingement on the switch, due to thermal expansion and contraction function, double sheet metal expansion deformation, the top opening switch off the power.

Q:I just bought a Japanese kettle. The voltage is one hundred volts. Could you use my power?

You'd better not use it directly. Buy a transformer.China voltage is 2 times of japan. The kettle power will be increased to the original four times. In other words, you burned a pot of water ten minutes ago, now only 2.5 minutes. This power is fast catching up with air conditioning. Air conditioning is a single line.The kettle is plugged in, and your wires and boards are unlikely to stand.The other 4 times the power also has damage to the kettle.The proposal is not used directly