1.5 Litre Double Layers both food grade plastic and 201# S.S. Electric Kettle

Ref Price:
Loading Port:
Shekou
Payment Terms:
TT OR LC
Min Order Qty:
3000 pc
Supply Capability:
100000 pc/month

OKorder Service Pledge

Quality Product

Order On-line Tracking

Timely Delivery

OKorder Service Pledge

Credit Rating

Credit Services

Credit Purchasing

Share to:

Product Description:

1.5 Litre Double Layers both food grade plastic and 201# S.S. Electric Kettle


Specification:

Capacity: 1.5L, power: 1500W

Voltage: 220V/50Hz

Food-grade enviromental plastic PP

Double thermostat, high-efficiency and energy saving

360 degree rotational base

Anti-dry and power off automatically

Fast boiling, only 4 minutes

 

 

Packing: 

Gift box: 195*180*200mm/pcs

Carton: 600*375*460mm, 12pcs/ctn

 

 

Loading:

3420pcs/20GP, 6900pcs/40GP, 8048pcs/40HQ

Send a message to us:

Remaining: 4000 characters

- Self introduction

- Required specifications

- Inquire about price/MOQ

Q:Why electric kettle leakage?
Electric kettle heating part of the insulation can not meet the requirements, or by voltage breakdown, or leakage of water may leak.The heating wire of the electric kettle is installed in the stainless steel metal tube, the gap between the heating wire and the metal tube tightly filled with good thermal conductivity and dielectric properties of crystalline magnesium oxide powder, if the heating wire from the metal wall too close to a violent bump, vibration, it is possible to contact each other, resulting in leakage.When the power cord is long and the outer skin is damaged, the leakage will also occur.As the electric kettle current is larger, partial contact is bad, resulting in contact resistance will bring local high temperature, burning, carbonization, destruction of insulation, will cause leakage.If there is water to between a conductive part and a kettle body, will cause leakage.There are some quality, but hard, congenitally deficient, and the quality of hidden products into the market, you have encountered.So we should avoid the bump, do not pull the plug, water not too full to overflow, into the conductive part.Electric kettle should use a three protection plug and socket wire connection, it is best to use a power supply circuit leakage protector.Electric kettle should buy double insulated products, plastic case of the best, metal shell of single insulation, try not to use.
Q:Can electric kettles cook rice dumplings?
When using an electric kettle, you must first load the water and then turn on the electricity. You must not let the electricity go on and then fill it with water. Pour water into the pot. At least you should have the lowest water level, but not exceed the required maximum water level. An electric kettle can not be used to boil things containing acid, alkali and salt so as to avoid corrosion of the kettle body and heater. And often remove the scale or other stains on the electric heater, otherwise it will affect the thermal efficiency and service life of the electric heater. When the electric kettle is not in use, it should be placed in a dry place so as not to damp and reduce the safety performance.
Q:How much power does a kettle have in general? How much electricity does it take to boil it?
About once 0.08~0.15 degrees of water or so, that is, a kilowatt hour, about 6~12 times
Q:The electric kettle suddenly stopped working
Prepare a cross screwdriver first, so long as you can unscrew the three screws at the bottom of the kettle.
Q:How to deal with leaking water at the bottom of an electric kettle?
The water leaked from the bottom of the kettle, this situation is electrothermal disc caused by bad water sealing, seal and sealing rubber like a pressure cooker that almost translucent, removed, cleaned (including electric disc also to clean up) and then put something on the line.
Q:Working principle and maintenance of electric kettleWhat is the principle often bad place where ah
If the steam switch failure, the water in the kettle will always burn down, until the water is boiled, the sharp rise in the temperature of the heating element, heating plate at the bottom of the two double metal sheet, because of the effect of heat conduction temperature rose sharply, the swelling deformation
Q:Electric kettle boil a pot of water, about ten minutes or so, how much electricity will use?
Ten minutes to boil a pot of water, the power should be 1500-2000W. One thousand watt hour for 1 degrees. To some projections, power consumption at about 0.3 degrees
Q:Electric kettle 304 good or 6D good?
Vacuum heating kettle, of course.At present, the market can be called "true insulation" electric kettle has a vacuum insulation kettle, electric water bottle / plug electric insulation kettle
Q:The electric kettle is dry. Can it be repaired? What about the warranty?
Electric kettle burning generally has two kinds of circumstances: one is a long time dry burning, resulting in deterioration of the heating disk damage, and the other is to prevent overheating of temperature controller or temperature pipe damage or fuse.
Q:Black spots on stainless steel kettle bottom
I dare not say that you said this pot has no problem, first of all, from the bottom of the pot pot material, there is such a situation you said, may be due to manufacturing pot material containing other ingredients, is not entirely stainless steel;Secondly, there may be the heating part of the lake too close to the bottom of the kettle, heating due to high temperature, the cooling effect of water, the chemical properties of the pot is changed, if carefully polished with sandpaper, you can remove the black class,Although this problem occurs, but it will not affect the use of temporary, as long as the temperature of the water boiling, you can achieve the purpose of sterilization.Suggest buying a water dispenser, not expensive, but also convenient

1. Manufacturer Overview

Location
Year Established
Annual Output Value
Main Markets
Company Certifications

2. Manufacturer Certificates

a) Certification Name  
Range  
Reference  
Validity Period  

3. Manufacturer Capability

a)Trade Capacity  
Nearest Port
Export Percentage
No.of Employees in Trade Department
Language Spoken:
b)Factory Information  
Factory Size:
No. of Production Lines
Contract Manufacturing
Product Price Range