Q:Principle and application of rammer

Ramming machine power rammerCompaction machine for tamping compacted backfill soil by impact and impact vibration. Sub fire rammer, breaststroke tamping rammer and etc..Thermal rammerAccording to the principle of two stroke internal combustion engine, there are two upper and lower pistons in the cylinder. The upper piston is an internal combustion piston, and the lower piston is a buffer piston. The lower part of the cylinder is fitted with a rammer with an inclined bottom to deflect the vertical axis of the cylinder toward the front. The piston rod from the through hole of the cylinder cover in the middle reach of piston rod from the lower end of the cylinder and hammer out and integrated between cylinder and hammer with spring tension, direction and a handrail is arranged to control the rammer. The fire is rammed under the action of the explosive force of the combustible mixture, so it jumps off the ground from the top to the top, and then hits the ground and strikes the soil under the weight of itself. The hammer falls and the body moves forward step by step.

Q:Internal combustion tamping machine belongs to what type of compaction machinery

According to the principle of two stroke internal combustion engine, there are two upper and lower pistons in the cylinder. The upper piston is an internal combustion piston, and the lower piston is a buffer piston.

Q:Gasoline rammer black smoke is what reason

The mixture is too strong. So they smoke.

Q:What if the oil for two stroke ramming machine diagram? What are the requirements for the viscosity grade? Urgent!

This motorcycle will use the oil. 10w/40 can be used. I hope my answer can help you.

Q:Near the ramming machine that have sold near me

There is no alternative, just as the flowers are no longer the flowers of that timeFull of deep unwillingness and weakness

Q:The story of a ramming machine on the trip what's wrong.

Value, and insulation and casing, take a look at what you do not understand can ask me again, I hope to help you, also hope you click adoption

Q:The slope, there is a tamper budget, is the ramming area is how calculated?Because is the rammer labor costs so much to calculate the consolidation area altogetherIn particular, the area needed to fill the slope (I would like to know what the area is) rather than the entire surface area

No matter how many layers, the floor area of the ground surface is constant, so the area required by the ground surface is calculated.

Q:What are some of the electric ramming machine accessories?

and strip rope block, centrifugal speed limiter, brakes, motor keys, rope inlet pipe, tube, wire rope, rope block block cover plate, screw, motor junction box and a rectifying device, a rope pressing device, gear shaft, vertical motor, turbine pin, vertical motor roller, distribution box,

Q:after a period of time, the heating of the motor leakage protection trip (acceptedwithout good). After cooling for a period of time, is it possible that the motor insulation value is small? 20Vertical rammer, after a period of time, the heating of the motor leakage protection trip (acceptedwithout good). After cooling, can use for a period of time again, is the motor insulation value small and overloaded?

Is the old, poor mechanical properties, motor overload, leakage protection if it can be adjusted to adjust, can not maintain the tone on rammer, change a little larger leakage protection, can be, the original motor is not hot, do not pay attention to is the trip.

Q:Carburetor gasoline leak automatic ramming machine

The oil needle on the carburetor float doesn't seal properly. Just open it and clean it